#Lath and plaster wall texture install

Please wait for the second layer of the compound to dry again before sanding it down with a sanding block.Īdd compound to seams and joints after you hang the sheets for textured drywall, and then create your desired texture when it’s dry. Step FiveĪfter you finish the fourth step, allow the compound to dry overnight before repeating the process for a second layer. Then use some lightweight joint compound and a putty knife to cover all other seams and joints. Once you secure the drywall, if you finish with a smooth wall, use a putty knife to fill in any gaps or crevices in each joint. Once you attach your new drywall boards, you can finish by applying joint compound and mudding corners with mesh tape.Ĭonsider using paper tape for extra reinforcement in areas like corners that entertain a lot of movement or stress on the board, such as near doorways or windows. If you don’t secure the boards, they will quickly become loose. It is best to understand that this is an important step. To do this, you’ll want to use drywall screws or nails rated for 1/2 thick drywall.Įnsure the screws are firmly driven into the lath and plaster, as they will ensure a secure connection between them and the new drywall board. Start by attaching the drywall at the top of a wall, then work your way down. Once your wall is clean and ready, you must nail the drywall. You can clear the wall using a broom, vacuum, or air compressor. Remove all loose, flaking material from the surface and brush off all dust. The first step in installing drywall over lath and plaster is to prepare the walls.

#Lath and plaster wall texture install

Steps to Install Drywall Over Lath Step One Utility knife or saw and a putty knife.Here are some materials you will need in installing drywall over the lath. However, it would help to know that when doing it yourself, it can be a time-consuming and tedious process. Installing drywall over lath and plaster is a project anyone can do with the right tools, safety equipment, and know-how. It will help create a strong bond and prevent any cracking down the line. Remember to tape any corners where two pieces meet as well. To avoid cracking or buckling of the drywall, use mesh tape around all of your seams before applying the joint compound. Check for NailsĪ forgotten nail sticking out of an old lath strip could puncture or damage your new drywall.Īs such, It’s essential to search for any nails sticking out before you install your new drywall, as they can be dangerous if they come loose while drilling. You can use a keyhole saw for the job and ensure you do all the cutting before installing the drywall.ĭoing so gives you room to screw the drywall over the areas without damaging them. Cut Around Electrical OutletsĮnsure to cut around any electrical outlets or fixtures. Ensure that the screws go in deep enough (about 1/4 inch) so that they will stay in place. Self-tapping screws attach the drywall to the lath strips, which are then secured to the ceiling joists. If you consider putting drywall over your lath, try the tips below. You can only have a successful project when you follow the proper installation steps and use quality tools. However, before you venture into the project, you must arm yourself with the right supplies, quality materials, and a plan for each process step.

Putting drywall over lath is a great way to modernize your old walls without removing the existing structure. Yes, you can put drywall over lath and plaster.